[. . . ] € Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. € If the power is not turned ON (“PROTECT” is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. [. . . ] € This unit has the cooling fan (page 5) to decrease the internal temperature. Do not mount the unit in a place where the cooling fan of the unit are blocked. Blocking these openings will inhibit the cooling of the internal temperature and result in malfunction. € Do not press hard on the panel surface when installing the unit to the vehicle. 2WARNING • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. 18 2:51:37 PM Connection Ignition key switch ACC If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. A B A B C Ignition wire (Red) Battery wire (Yellow) Ground wire (Black) (To car chassis) Antenna Cord Car fuse box Car fuse box (Main fuse) + – C Battery Connect to the vehicle's parking brake detection switch harness. Parking sensor wire (Light Green) PRK SW For the sake of safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote Reveres sensor wire (Purple/White) Steering remote control input (Light Blue/Yellow) To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. Dimmer control wire (Orange/White) To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. Mute wire (Brown) Motor antenna control wire (Blue) Power control wire (Blue/White) If no connections are made, do not let the cable come out from the tab. CONT White/Black White + To front left speaker FRONT R Gray/Black Gray + ILLUMI To front right speaker REAR L MUTE Green/Black Green + To rear left speaker REAR R Purple/Black Purple + To rear right speaker ANT. [. . . ] Insert the two removal tools 3 deeply into the slots on each side, as shown. Removal Tool (Accessory 3) Catch Lock ⁄ • The frame can be removed from the top side in the same manner. Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. [. . . ]